Jump to content
Corsair Community

just got 6600 need help overclocking

Recommended Posts

Processer: Intel Core 2 Quad CPU (Q6600) @ 2.40Ghz

Ram: TWIN2X4096-6400C5DHX

MotherBoard: Ip35 Pro

CPU Fan: Zalman CNPS9700NTUniversal Cooler

Power Supply: Corsair CMPSU-750TX 750W



I was wondering if someone can point me in the right direction in overclocking my CPU to at least a 3.0. Or if someone can walk me through it plz. Thank You

Link to comment
Share on other sites

Download memtest from--->
and extract the ISO image. Burn the ISO image to an CD-ROM disk.

SoftMenu Setup


JumperFree Configuration Settings

AI Overclocking = Manual

CPU Ratio Control = Manual

- Ratio CMOS Setting = 9

FSB Frequency = 333

PCI-E Frequency = 100

DRAM Frequency = DDR2-800

DRAM Command Rate = 2T

DRAM Timing Control = Manual

CAS# Latency = 5

RAS# to CAS# Delay = 5

RAS# Precharge = 5

RAS# Activate to Precharge = 15

TWR = Auto

TRFC = Auto

TWTR = Auto

TRRD = Auto

TRTP = Auto

DRAM Static Read Control = Auto


Transaction Booster = Auto

Boost Level = N/A

Clock Over-Charging Mode = Auto


CPU Spread Spectrum = Disabled

PCIE Spread Spectrum = Disabled


CPU Voltage = 1.35v

CPU Voltage Reference = Auto

CPU Voltage Damper = Enabled

CPU PLL Voltage = 1.50

DRAM Voltage = 1.9

FSB Termination Voltage = Auto

North Bridge Voltage = Auto

North Bridge Voltage Reference = Auto

South Bridge Voltage = Auto

Advanced CPU Settings

CPU Ratio Control = Manual

Ratio CMOS Setting = 9

C1E Suppport = Enabled

Max CPUID Value Limit = Disabled

Vanderpool Technology = Disabled

CPU TM Function = Disabled

Execute Disable Bit = Disabled

PECI = Disabled


333 X 9 ~= 3.0Ghz. Boot to the Memtest CD allowing for two full passes.



Link to comment
Share on other sites

is it possible to make it any faster like...to the point where it is like the most u can overclock it, then maybe like 2 steps below it.



(max overclocking)



3(i wanna be like here)







(2.40 no overclocking)


wts teh max u can overclock a q6600 with my setup then take it like 2 or 3 notches down plz. Thank you

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...