Jump to content
Corsair Community

Problems with new rig.


Cerwin

Recommended Posts

I put together a new system (Specs clickable above) and I'm having some problems.

 

2x sets of TWIN2X2048-8500C5D (4 sticks total) in an Asus Maximus Formula for quick reference.

 

It's crashing at random intervals unless I run the memory as ddr2-800. Once I run the memory as ddr2-800 it runs fine; but I would like to run my memory to it's fullest potential. How can I get this running up to speed?

 

Also, in vista 32bit, it shows 2.25gb of memory. Is this because I have 2 vid cards with 1gb of ram each? My friends system shows 3.25 gb with 1x 8800gts 512.

 

Thanks in advance for all the help.

Link to comment
Share on other sites

They ARE DDR2-800 sticks, so that's normal! In fact, normally with 4 sticks you'd have to lower it to 667, so if they're running fine @ 800, then all the better.

 

Yes, 2.25 due to 32-bit and 1 GB video cards. Are you planning on upgrading to a 64-bit OS later? If not, that's a whole lot of memory that's gone to waste.

Link to comment
Share on other sites

Gotcha. The speed's still normal then. As I mentioned earlier, 4 x DDR2-800 should be run @ 667, and the same idea applies to 4x DDR2-1066, in that they should be run @ 800. You'd have to OC the system to get back some of the speed.

 

4 sticks place a larger load on the memory controller than 2 sticks.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...