Jump to content
Corsair Community

K8V and CMX512-3200LLPRO ?????????


ou812

Recommended Posts

RamGuy,I have a ASUS K8V ,3200+ AMD64,and would like to run 1 stick of your CMX-3200LLPRO 512MB to start off,but would like to add another stick of the same in about 1 months time.Are there special timings I would need to apply or change any voltage settings with either the 1 stick or the 2 sticks.I see with the TWINX you recommend to use slot 1 and 3 and to set the voltage to 2.7.TIA :confused:
Link to comment
Share on other sites

  • Corsair Employees
No! Just use slot one for now, but when you get the new module. Reset the bios or just load setup defaults and set the timings again and you should ready to rock! Just a note, I would not wait too long to get the second module as Winbond has stopped all production or will be very soon so this speed grade may become herd to get in the near future!
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...