Jump to content
Corsair Community

Memory running at wrong latency


DjStuntscw

Recommended Posts

Hi there,

 

I recently purchased 2 1 gig sticks and 2 512 sticks:

 

Corsair 1GB Kit (2x512MB) DDR2 800MHz/PC2-6400 XMS2 Memory Non-ECC Unbuffered CL4(4-4-4-12) Heat Spreader Lifetime Warranty

 

and

 

Corsair 2GB Kit (2x1GB) DDR2 800MHz/PC2-6400 XMS2 Memory Non-ECC Unbuffered CL4(4-4-4-12) E.P.P. Heat Spreader Lifetime Warranty

 

My friend is getting higher scores on the Vista Performance tab with the 2 1 gigs alone than i'm getting with both.

 

I browsed for the problem and u mentioned to use Everest, but the one i found didn't work on Vista 64bit.

 

So i used cpuz and it came up with these results:

 

http://img507.imageshack.us/img507/8553/memory2rq4.jpg

 

How can i get it to the correct settings in the BIOS? Don't want to mess about too much and break the memory :D

 

Any help appreciated :)

Link to comment
Share on other sites

  • Corsair Employees
That is normal when adding more memory and the Performance tab will not increase. And that is not a memory benchmark. It would be best to use just two modules for best performance then then load setup defaults and set the tested settings manually for the specific part you have.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...