Jump to content
Corsair Community

P4C800-E Deluxe & 3200 LLPT


Recommended Posts

I have the asus P4C800-E Deluxe and 3200 LLPT(rev 1.1) ..I've been tring to overclock for a while since I've just gone over to a full water colling setup..but no luck there but going back to standard settings I've run into stability problems...after much testing I belive the memory to be the problem..hence my post :): I've set the bios Dram frequency @ Auto (which is 400 or 1:1 ) memory was @ 2-2-2-6 and voltage to Auto testing with memtest86 (using option C ,2,5,4..then Enter twice) memtest didn't give any errors but it locked up after pass 2 this happend 3 times around this area ...changed voltage to 2.75V and settings to spd it also crashed again twice... Any other settings I should try ?(just rememmberd I had usb legacy support set to auto ..I'll try disabled and see that works)...or do you think it may be faulty ram ??? Many thanks .. :o:
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...