fogline Posted January 15, 2008 Share Posted January 15, 2008 I looked around and did several searches but was unable to find specific info on this setup: p5n32 sli se deluxe mb running the DDR2 4GB (2X2GB) PC6400 DUAL / TWIN2X4096-6400C5DHX CORSAIR memory. I am using vist pro and have the sticks in now and all is running but it shows in the post that it is running at 800 / 16-1-1-1-1-1 (or something near identical. I am at work right now) I will have to grab some other program to make sure of the timings but I am pretty certain this is incorrect. Also, what should the voltage be set at. I need no overclocking as all is running at factory settings. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 15, 2008 Corsair Employees Share Posted January 15, 2008 These modules TWIN2X4096-6400C5DHX can run at default voltage so just install the modules and load setup defaults is all you have to do the SPD is set to Cas 5-5-5-18 at 1.8 Volts and the tested settings Cas 5-5-5-15 at 2t would or should be manually set. And with that MB I would set the Command Rate manually at 2t and set the TRC to 24. You should be good to go. Link to comment Share on other sites More sharing options...
fogline Posted January 15, 2008 Author Share Posted January 15, 2008 thank you for the prompt reply!! Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 15, 2008 Corsair Employees Share Posted January 15, 2008 NP Please let me know if you have any more questions! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.