weddellkw Posted August 16, 2007 Share Posted August 16, 2007 Received a C1 (base memory detect) at first boot up w/ both sticks in (slots 0/1 & again slots 2/3). In slot 1 stick A will proceed to a 52 (Memory Test - Test all memory of memory above 1MB using Virtual 8086 Mode, Page Mode and clear memory) and stick B stops at C1 again. I'm stuck at this point. Suggestions? Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted August 16, 2007 Corsair Employees Share Posted August 16, 2007 Please make sure that you have the latest Bios version and then load setup/optimized defaults and set the Dim Voltage to 2.0 volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.