Jump to content
Corsair Community

520W Problem


jdl1681

Recommended Posts

I have a Corsair 520 PS. I just upgraded recently from an 3800 X2 939 W/ 2GB of DDR to a E4400 C2D W/ 2GB of DDR2 800. Today I boot the systems and I start receiving memory error so I pull the sticks each test perfectly by solo but will not boot together. I then decide to check my P/S voltage through both everest and speedfan and they show the +12 Rail between 9.5 and 10.5.

 

I am currently running an EVA 650i with a E4400. With 2GB of G.Skill DDR2 with a 7950GT and a SB X-FI. Along with 1 DVDR/W 1 Raptor 36 GB and 1 160GB WD SATA Drive.

 

I would not think this rig would stress a 520 that must is it time for an RMA?

Link to comment
Share on other sites

  • Corsair Employees
Is it possible to test your modules in a different system to see if you are having the same issues? Also make sure you have the memory voltage set correctly for the specific modules you are using.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...