Jump to content
Corsair Community

Correct way to install GPU in Nautilus 500


Antuans

Recommended Posts

Hi have good day :biggrin:

 

Im confused im not sure ...if i install GPU nautilus , need i cut both tubes ,line in and line out and use splitter to join again? or i only need cut one (line out) ???? :confused:

Link to comment
Share on other sites

Yes that is correct, but you can do it either way, most do it this way as far as I know!

 

series - YES.... cos no need to calibrate flows

 

parralle - NO.... for need to balance flow rates with each WB off the branch.

 

also note: in/out lets orination best have inlet on the lower half of cpu with outlet beening the highest

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...