Jump to content
Corsair Community

I have a bad memory module.


Recommended Posts

  • Corsair Employees
Please make sure that you have the latest Bios version and then load setup/optimized defaults and set the Dim Voltage to 2.75 volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

OK. I went and tested it again with the following conditions: I have the latest BIOS, 2.75v, 2-3-3-6 with a burst speed of 4, legacy USB off. I got the following results:

 

TEST # of Errors

1 74

2 114

3 18481

4 9125

5 240

6 451

7 7466

8 2390

 

 

The area of memory indicated was 1015.0MB, 1015.1MB, 1015.5MB, and 1015.6MB.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...