Jump to content
Corsair Community

P5N32-E SLI PLUS + TWIN2X2048-6400 Set X2 = Not Working


Daimadoshi

Recommended Posts

Hi, i saw another thread about the same card and 4 Go of Ram, so i had set the Voltage to 2.1 and the Frequency at 667, but it still doesn't work. Do you have another idea of what i could do to make it works ?

 

Thank you for your time.

Link to comment
Share on other sites

  • Corsair Employees
Please make sure that you have the latest Bios version and then load setup/optimized defaults and set the Dim Voltage to 2.0 volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with some MB's (Mostly ASUS) you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...