Jump to content
Corsair Community

GA-965P-DS3 (Rev 2.0) & CM2X1024-6400


bengineer2324

Recommended Posts

When I first built my system it would hardly even boot. It would just turn on and then restart itself. I finally was able to change the voltage on the memory to +0.1v and that made it a little more stable, starting up about every other time (long enough for me to put Vista Home Premium on it).

 

Now every time I startup it gets all the way to the desktop after logging in and freezes. I'm wondering if I need to adjust my memory settings to get a more stable system.

 

Here are my current settings:

 

Robust Graphics Booster [Auto]

CPU Clock Ratio [ 9x ]

CPU Host Clock Control [Enabled]

CPU Host Frequency(Mhz) [266]

PCI Express Frequency(Mhz) [Auto]

C.I.A.2 [Disabled]

System Memory Multiplier (SPD) [3.00]

Memory Frequency(Mhz) [800]

High Speed DRAM DLL Settings [Option 1]

 

DRAM Timing Selectable (SPD) [Manual]

CAS Latency Time 5 [5]

DRAM RAS# to CAS# Delay 5 [5]

DRAM RAS# Precharge 5 [5]

Precharge Delay (tRAS) 18 [12]

ACT to ACT Delay (tRRD) 3 [Auto]

Bank Write to READ Delay 3 [Auto]

Write to Precharch Delay 6 [Auto]

Refresh to ACT Delay 42 [0]

Read to Precharge Delay 3 [Auto]

Memory Performance Enhance [Normal]

 

System Voltage Control [Manual]

DDR2 OverVoltage Control [+0.1v]

PCI-E OverVoltage Control [Normal]

FSB OverVoltage Control [Normal]

(G)MCH OverVoltage Control [Normal]

CPU Voltage Control [Normal]

Normal CPU Vcore 1.26250V

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...