Jump to content
Corsair Community

two sticks of 8500c5 and two sticks of 8500c5d


wamu

Recommended Posts

ok here it goes i have two sticks of 8500c5 and two sticks of 8500 cd5 from what i understand there both the same but when i run cpu-z the tic on my c5d is 22 and the tick on my c5 is 30 will this cause me any problems and also if anyone could elaborate more on this subjet i would apprecite it im running vista 32 and yeah i know it only shows as 3 gigs thankyou
Link to comment
Share on other sites

  • Corsair Employees
What do you mean by "TIC" there is no such setting. An if the system is stable it should be fine and just let the Bios set the timings and set the Voltage to 2.2 Volts, and you may have to run the memory frequency at 667 or 800 MHz.
Link to comment
Share on other sites

the tic i was refering to is in a program called cpu-z under the tab called spd then under table timings frequency is 533 next line is cas latency which says 0 for some dam reason next is ras# and cas#5 then ras#precharge 5 then trass 15 then tic 30 then command rate 2t so any hoo thanks for the help and am glad their are good techs out there to help like u
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...