Jump to content
Corsair Community

Intel BOXD975XBXLKR-TWIN2X2048-6400C4D


Warbear

Recommended Posts

After using Corsair for years, I researched the pair I wanted for my new motherboard. Fired it up and got "Serial Presence Detect failed or information missing - will attempt to set configuration. Setting to 533.. hit any button to continure.

 

I hit everybutton on my keyboard and nothing happens. I doubt that Corsair would recommend memory that was not compliant with the board, therefore I am sure this is SPD memory.

 

Can I not get to the bios because of this message? Or did I just miss the F2 chance before the message comes up, therefore enabling me to check the bios and make adjustments? And if you recommend adjustments, can you be specific.......its been 3 years since I built my last computer and everything has changed quit a bit since then.

 

Ideas would be welcome. I appreciate the help.

Link to comment
Share on other sites

Thanks Ram Guy. That did it. It picked up the first one right away,

then I shut down, inserted the second and both were there.

 

Since the latency is 5-5-5-15 I will now go back in and

change to 4-4-4-12 1.9-2.1 volts which if I read correctly is what

it should be showing.

 

I can do this through the bios or memtest?

Link to comment
Share on other sites

  • Corsair Employees
You will need to make the changes in your Bios and I would suggest you set the memory Voltage to 2.1 Volts and then set the timings but load setup defaults before you make any changes.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...