Jump to content
Corsair Community

Twin2x2048-6400c4d


vincel

Recommended Posts

Hi guys,

 

I just buy some Corsair memory Dominator TWIN2X2048-6400C4D.

My motherboard is an asus P5WS64 pro with the letest bios.

I can't see the logon when i put the two modules on the MB (Yellow bank only or Black bank only).

I decided to do a memtest to see if there is something wrong with it.

But a can't go trough the test, it hang at 16% or 19%. If i try the same test with the good module it passed.When i put the wrong one it hang at 16% or 19% again.

 

Did you think that there's some configuration on the mobo i messed up?:confused:

Or is my part wrong?:(:

 

Best regards.

Link to comment
Share on other sites

  • Corsair Employees
Please make sure that you have the latest bios and then load setup defaults and set the Dim Voltage to 2.1 volts and then set the timings manually to the tested settings for the specific module you have, and then test the module/modules one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with this MB you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Hi,

 

The latest bios is allready installed : Version 0402 2006/12/15

I try to disable the legacy USB, the RAM voltage is 2.1 and the memtest passed the 16% or 19% but hang at 50%.

I think that the module is wrong.

 

Best regards,

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...