Krytos Posted January 4, 2007 Share Posted January 4, 2007 I have an MSI K9N sli Platinum, and TWIN2X2048-6400C4D However, by default its only running at 1.85v I changed it to manual and changed the voltage to 2.1, and the necessary timings tp 4-4-4-12 , but there were a bunch of other settings that could be changed. I left them to auto, and rebooted the PC, about 10 minutes in, it reboots itself, without fail. Chagned the voltage and timings back to auto, and its stable. Any ideas? Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 5, 2007 Corsair Employees Share Posted January 5, 2007 Please load setup defaults and then set the Dim Voltage to 2.1 volts (+.2 Volts W/Giga-Byte) and then test the module/modules one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with this MB you have to disable legacy USB in the bios when running any memory test. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.