Bash Posted December 29, 2006 Share Posted December 29, 2006 Hello, I have bought 2 sticks of Corsair CMX1024 XMS3200 400MHz CL2. I been using it in single mode all this time with no problem. My motherboard NFI4 Lanparty SLI comes with slot1(yellow) slot2(Orange) slot3(yellow) slot4(orange). I used slot2 and slot4 to get dual mode benefit infact at one point had it working and got too window after 2 mins system lock up. Please help me get the full benfit from these 2 sticks. It works fine in single mode. Link to comment Share on other sites More sharing options...
Bash Posted December 29, 2006 Author Share Posted December 29, 2006 Am I at wrong place asking for help. I have no idea what is recommend timing are for my memory. Thank You Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 29, 2006 Corsair Employees Share Posted December 29, 2006 You are in the right place but it takes about 24 Hours for us to reply! And you posted last night at 11:30 PM, sorry but I was asleep then! Please make sure that you have the latest bios and then load setup defaults and set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. Link to comment Share on other sites More sharing options...
Bash Posted December 30, 2006 Author Share Posted December 30, 2006 Hi, I came in here to tell you i have figure out the problem before even read your thread. Sorry if i was so impatient. What i did was flash bios and the memory know under CPU-Z reads dual. Thanks for your help. I took this PC to local Frys Electronic where i bought the MB, and Memory. The techy told me that something is wrong with MB so i figure I try few more times n ask you guys before i ship the MB. Than, today i flash bios stuck both memeory thada! Hope this help others who has same set up like mine. RAM guy what is good Timing for the memory i got. It does not say anything on stick or the box it came in . That you posted is best numbers for mine ? Take care Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted January 2, 2007 Corsair Employees Share Posted January 2, 2007 XMS3200 modules are tested at Cas 3-3-3-8 at DDR400 at 2.75 Volts! And thank you for letting us know, please let me know if you have any more questions! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.