toanhoang76 Posted December 12, 2006 Share Posted December 12, 2006 At standard 1:1 ratio the computer goes into blue screen. Also, I did the memory test and get error. I had issues with these 2 rams before, but never had a chance to send it in for warranty. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 12, 2006 Corsair Employees Share Posted December 12, 2006 Can you tell me the make and model of MB you have along with the CPU speed and it’s FSB as well? In addition, please tell me the bios settings you have set for both CPU and memory and any performance settings that you may have set? Link to comment Share on other sites More sharing options...
toanhoang76 Posted December 13, 2006 Author Share Posted December 13, 2006 I have a Gigabyte GA-8IPE1000 Pro (Rev 2.x) and a P4 @ 2.4 FSB 800mhz. The bios setting is at factory setting. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 13, 2006 Corsair Employees Share Posted December 13, 2006 Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS3200C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. Link to comment Share on other sites More sharing options...
toanhoang76 Posted December 14, 2006 Author Share Posted December 14, 2006 Still having the same issues. Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted December 14, 2006 Corsair Employees Share Posted December 14, 2006 Let's get them both replaced. Please use the RMA request found in TSXpress or follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! And please note that you are from the forum! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.