Jump to content
Corsair Community

DFI LanParty nf4 Ultra-D and VS2GBKIT400C3


toppy4

Recommended Posts

I reset my CMOS and can't get my setting loading pass the windows startup screen, before it reboots.

 

It use to work fine at 3-3-8-3, but not anymore. Here are my current settings.

 

Tcl 3.0

Trcd 3

tras 8

trp 3

 

Trc 7

Trfc Auto

Trrd 3

Twr 2

Twtr 2

Trwt 3

Tref 3120 cycles

 

Any help would be appreciated.

 

Link to comment
Share on other sites

  • Corsair Employees
Please make sure that you have the latest bios and then load setup defaults and set the Dim Voltage to 2.7 volts and then test the module/modules one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with this MB you have to disable legacy USB in the bios when running any memory test.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...