Jump to content
Corsair Community

Bad TWINX2048-3200C2 Kit


Recommended Posts



I'm german, so my english is not very well. But i try to explain my problem.


I bought a TWINX2048 RAM kit. When these arrived, I built these directly into my computer. After several Bluescreens I set the Timings from 2-3-3-6 T1 to 4-4-4-12 T2 and start Memtest86+. This indicated several errors. Then I tested both RAMs individually and both have errors. What can I still do now? A CMOS CLEAR I already accomplished. Also i tried 2,8V on my mainboard, same results.


My Hardware is:

DFI Lanparty nF4 Ultra-D with latest offical BIOS

AMD Athlon64 X2 3800+

u can see the other Hardware in my profil.


The Warrenty of the Rams is allready run out, so i write this here. I hope someone of corsair can help me.


Here is a Screenshot from my screen when Memtest86+ was running -> click me to see the screenshot

On this screenshot u see the running test with 2-3-3-6 T1 settings. If a screenshot with 4-4-4-12 2T settings is needed here, i will run the test again and show the screen here.


so far...

Tobi for Germany


Sorry, for my bad english :)



I have tested the rams also on a ASUS board with nForce2 chip, and i also get errors like these on the screenshot. I hope someone can help me.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...