Jump to content
Corsair Community

Memtest shows consistent error in one module


bishr1

Recommended Posts

I have two modules purchased at the sametime. Recent system instability caused me to question the installed RAM. Both modules are 1GB Value Select and were purchased at the sametime.

 

All clock frequencies and voltage are default. Memory timings are set to auto from SPD. BIOS is current for the motherboard. Setting the timings to slower than rated values do not make a differnece.

 

One module shows consistent errors at two addresses. The errors follow the module if it is moved to a different slot. The second module shows no errors.

Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...