Jump to content
Corsair Community

Bad Module


Brian_324

Recommended Posts

recently purchased CORSAIR XMS2 1GB (2 x 512MB) 240-Pin DDR2 SDRAM DDR2 800. Bios settings were set to stable 5-5-5-15 like it was posted to. it was restarting every once in a while only reading 512MB and i would restart it and it would be fine for another few days. Then again....and so on. Finally one just crapped out. Any help? Bad part? thanks in advance
Link to comment
Share on other sites

  • Corsair Employees
Please make sure that you have the latest bios and then load setup defaults and set the memory voltage to 2.1 Volts and set the settings manually to the tested settings as long as you have a MB that will support 800 MHz memory.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...