telegraham Posted October 7, 2006 Share Posted October 7, 2006 Configuration: 1 Each CMX1024-3200C2 2 Each CMX512-3200C2 CAS 2.5-3-3-6-1T @ DDR200 Problems began with intermittent BSOD. I ran MEMTEST86+ on each stick individually. Both CMX512s checked good. The CMX1024 had multiple errors. Please see screen shot here. Please advise. Thanks. Jim Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted October 9, 2006 Corsair Employees Share Posted October 9, 2006 Jim, First thing, you cannot run at 1t Command Rate with more than one double sided module. Next thing I would not suggest mixing 512 Meg and one Gig modules in any system, and with this MB if you install 2 double sided modules you should run at DDR333 and with Three double sided modules DDR200 is suggested. Please check your user manual. And I would test the suspect module by it self after you load setup defaults and then set the tested settings with http://www.memtest.org to be sure. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.