Jump to content
Corsair Community

twinx1024-3200c2pt problems


sisith

Recommended Posts

Hi, I just RMA'ed my old sticks and recieved two new fresh ones. The problem is, the new ones will not work in dual channel mode whereas the old ones did. My comp secs are:

Gigabyte GA-K8NS-939

Athlon XP 3200+

ram mentioned above

 

Everything was working fine until one of my old modules went bad and I had to RMA them. Now whenever I plug the modules into DIMM slots 1 and 2 (dual channel), I get the bios beep that says there are problems with my ram and it doesnt post. If I put either stick in seperately into any of the slots it works fine. If I put the ram into slots 1 and 3 (not dual channel), it boots up but only shows 512 ram. I have raised the voltage .2 like recommended and still no change. Also both the revisions and part numbers are exactly the same. What could be wrong here?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...