MFK Posted October 5, 2006 Posted October 5, 2006 Hi Ramguy i have 2 VS512MB400 Modules in Dual Channel Use. I get CRC Faults when I handle with data bigger 600 MB ca. I'cant unpack or copy or make anything whit that. I tested booth modules with MEMTEST86 and I got over 2000 faults . Because I have to work i bought today a 1GB Modul from CORSAIR . And now there are no more problems. What do I have todo with the 2 other moduls ? Thx Mark from Germany
Corsair Employee RAM GUY Posted October 5, 2006 Corsair Employee Posted October 5, 2006 Please try your reseller first but before you do I would put these modules back in the system and load setup defaults and then set the memory Voltage to 2.75 Volts and Disable legacy USB and test the modules one at a time with http://www.memtest.org to be sure one is not failing!
MFK Posted October 5, 2006 Author Posted October 5, 2006 Setup Defaults i tryed before. But I didn't found where I can change the ram voltage .
Corsair Employee RAM GUY Posted October 5, 2006 Corsair Employee Posted October 5, 2006 Its under Jumper Free Configuration!
MFK Posted October 6, 2006 Author Posted October 6, 2006 So i changed to 2.75 V . I tryed again every module alone an then both together but there is no change. I don't want to go over my reseller because it takes to much time. He will test again and again... and send it then to you.
Corsair Employee RAM GUY Posted October 6, 2006 Corsair Employee Posted October 6, 2006 Let's get them replaced. Please follow the link in my signature “I think I have a bad part! Or *New* Tech Support Express” and we will be happy to replace them or it, please note that you are posting from the forum!
Recommended Posts
Archived
This topic is now archived and is closed to further replies.