Jump to content
Corsair Community

My Ram is going bad


bradteebee

Recommended Posts

I have changed out every peice of equipt in my comp but the Ram and i am still having the same problem, I have to hard restart and my comp sometimes starts up. So i went to the forums and one of the reasons that was listed was that the problem could be caused by one or more sticks or ram going bad.
Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. With this MB you have to disable legacy USB when running http://www.memtest.org as well.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...