mark956101957 Posted September 14, 2006 Posted September 14, 2006 Hi Everyone. I have the hoses and CPU waterblock arranged and screwed down, the two power wires hooked up to a 4 pin molex, now all I need is for the two wires, one for the fan control and one for the pump speed to be hooked up to a fan header each. The problem is this Shuttle board has few options and I was wondering if anyone can help me out here with where to hook up these singles wires connected to a three pin fan connection each? Any work around, I can splice, rewire whatever it takes, I just need some alternatives since this Shuttle is so small and limited. Thanks.......
ira-k Posted September 14, 2006 Posted September 14, 2006 Hi Everyone. I have the hoses and CPU waterblock arranged and screwed down, the two power wires hooked up to a 4 pin molex, now all I need is for the two wires, one for the fan control and one for the pump speed to be hooked up to a fan header each. The problem is this Shuttle board has few options and I was wondering if anyone can help me out here with where to hook up these singles wires connected to a three pin fan connection each? Any work around, I can splice, rewire whatever it takes, I just need some alternatives since this Shuttle is so small and limited. Thanks....... The white wire should attach to your cpu fan header and the green to a case fan header. I don't know anything about your mobo, but you should have a cpu fan header. Any way you don't have to connect the green or white wires for your unit to function, they just monitor your fan and pump speed.
mark956101957 Posted September 15, 2006 Author Posted September 15, 2006 The white wire should attach to your cpu fan header and the green to a case fan header. I don't know anything about your mobo, but you should have a cpu fan header. Any way you don't have to connect the green or white wires for your unit to function, they just monitor your fan and pump speed. Thanks for the response you are right I just needed the red and black for the power and don' need to bother with the other two. Thank you.... :laughing:
KaptCrunch Posted September 16, 2006 Posted September 16, 2006 I'd use the the 3 wire if pump has them, SN25P manual on page 36 section E2 shows it has 4 fan headers with new style PWM(forth wire). for if any failure it will shut down system using the CPU fan header on the pump.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.