princealexi Posted September 13, 2006 Share Posted September 13, 2006 Mem Configurator does not contain my MB, can you please help? I'm looking to get 2x1GB in a twin pack, preferably. Probably value line.... Thank you for choosing the 865 PE/G Neo2 (MS-6728) v1. X ATX mainboard. The 865 PE/G Neo2 is based on Intel® 865PE/ G & ICH5 chipsets for optimal system efficiency. Designed to fit the advanced Intel® Pentium® 4 processors in 478 pin package, the 865 PE/G Neo2 delivers a high performance and professional desktop platform solution. MS-6728 ATX Mainboard Mainboard Specifications CPU Supports Intel® P4 Northwood/Prescott (Socket 478) processors. FSB 400 (for Northwood only), 533, 800MHz, depending on the integrated North Bridge. Supports up to 3.6GHz or higher speed. Chipset Intel® 865PE/G chipset - Supports FSB 800/533/400MHz. - Supports AGP 8X interface. - A Gigabit Ethernet (GbE) controller is supported through the CSA (Communications Streaming Architecture) interface. - Supports DDR 400/333/266 memory interface. Intel® ICH5/ICH5R chipset - Hi-Speed USB (USB2.0) controller, 480Mb/sec, 8 ports. - 2 Serial ATA/150 ports. - 2 channel Ultra ATA 100 bus Master IDE controller. - PCI Master v2.3, I/O APIC. - Supports both ACPI and legacy APM power management. - Serial ATA/150 RAID 0 (Optional). Main Memory Supports four unbuffered DIMM of 2.5 Volt DDR SDRAM. Supports up to 4GB memory size without ECC. Supports Dual channel DDR266/333/400 MHz and up. Slots One AGP slot supports 8x/4x at 0.8V (AGP 3.0) or 4x at 1.5V (3.3V is not supported). Five 32-bit v2.3 Master PCI bus slots (support 3.3v/5v PCI bus interface). On-BoardIDE Dual Ultra DMA 66/100 IDE controllers integrated in ICH5/ICH5R. - Supports PIO, Bus Master operation modes. - Can connect up to four Ultra ATA drives. Serial ATA/150 controller integrated in ICH5/ICH5R. - Up to 150MB/sec transfer speeds. - Can connect up to two Serial ATA drives. - Supports SATA RAID 0 (Optional). 1-3 Getting Started Promise 20378 On-Board (Optional) Supports Ultra ATA, Serial ATA, Ultra ATA RAID 0 or 1 , Serial ATA RAID 0 or 1, Ultra/Serial ATA RAID 0+1 supported. Connect up to 2 Serial ATA devices and 2 Ultra ATA 133 devices. On-Board Peripherals On-Board Peripherals include: - 1 floppy port supports 2 FDDs with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes - 1 serial port COM1, 1 VGA port (for 865G only) (Optional) - 1 parallel port supports SPP/EPP/ECP mode - 8 USB 2.0 ports (Rear * 6/ Front * 2 or Rear * 4/ Front * 4) - 1 Line-In/Line-Out/Mic-In port - 1 RJ45 LAN jack (Optional) - 3 IEEE 1394 pinheaders (Optional) Audio 6 channels software audio codec C-Media 9739A. - Compliance with AC97 v2.2 Spec. - Meet PC2001 audio performance requirement. - Can support SPDIF Out via S-Bracket only. LAN (Optional) Intel® 82547EI (CSA interface) /Intel® 82562EZ Dual layout. - Integrated Fast Ethernet MAC and PHY in one chip. - Supports 10Mb/s, 100Mb/s and 1000Mb/s (1000Mb/s only for Intel® 82547EI). - Compliance with PCI 2.2. - Supports ACPI Power Management. BIOS The mainboard BIOS provides “Plug & Play” BIOS which detects the peripheral devices and expansion cards of the board automatically. The mainboard provides a Desktop Management Interface (DMI) function which records your mainboard specifications. Dimension ATX Form Factor: 30.5 cm (L) x 24.4 cm (W). Mounting 9 mounting holes. Link to comment Share on other sites More sharing options...
princealexi Posted September 13, 2006 Author Share Posted September 13, 2006 The board is an MSI.... Link to comment Share on other sites More sharing options...
Corsair Employee RAM GUY Posted September 13, 2006 Corsair Employee Share Posted September 13, 2006 What is the speed of the CPU you plan on using? If its 800FSB I would suggest VS2GBKit400C3 with that MB. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.