Jump to content
Corsair Community

One part is bad (TwinX cmx 512 3200c2)


tonsc

Recommended Posts

I think one my memory modules is bad. I had problems with a few programms and my pc crashes last time very often.

 

I tested both with memtest86 and with the microsoft ram diagnostic tool.

One works, but when I tested the other in the same slot as the one before I got failures.

 

(Cas 2.5-3-3-8)

 

What do I need to be able to send it back to you or is there still a possibility to fix the problem?

 

Its about 3 years old. What can I do when I dont have the receipt anymore?

Do I have to send it to the United States or is it also possible in Europe?

Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...