Faulty Memory

[gezza]

Hi,

 

I have 1 x TWINX1024-3200C2PT and 1 x CMX1024-3200C2PT

Both used to work fine for about a year until I started to get system crashes.

I ran memtest with the CMX1024-3200C2PTB only. Memtest passed.

I ran Memtest with the TWINX1024-3200C2PT only. Memtest failed.

Can I retrun TWINX1024-3200C2PT?

 

Thanks

Gezza

[RAM GUY]

First thing you cannot mix these modules they will not run in D/C.

Please install the modules one at a time and load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS3200C2 Cass 2.5-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.

[gezza]

If I find that the TwinX is faulty, do I return both TwinX modules or just the faulty one?

[Wired]

you would return both, as quantity 1 of twinx

[gezza]

Can I have an RMA Number please.

 

Thanks

Gezza

[RAM GUY]

Please use the RMA request found in TSXpress or follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! And please note that you are from the forum!