Jump to content
Corsair Community

Asus P5B Deluxe Correct Settings?


Smitty27

Recommended Posts

Hello, I am setting up my new Core 2 Duo system and I have a question about the proper settings for my TWIN2X2048-6400C4PRO. The auto detection picked the SPD at 5-5-5-12, so I manually configured:

 

DRAM CAS# Latency - 4

DRAM RAS# to CAS# Delay - 4

RAS Precharge - 4

RAS Activate to Precharge - 12

Write Recovery Time - 6

DRAM TRFC - 30

 

The first 4 settings above are obvious, but what about the other values? What should they ideally be? I looked on the spec sheet and they aren't listed. Also, should I set the voltage to 2.10V? I am using the latest BIOS, 0405. Thanks for your help!

Link to comment
Share on other sites

  • Corsair Employees
Yes set the Voltage to 2.1 Volts and any setting thats not listed should be set the bios default. I would just load setup defaults and then set the settings and voltage and you should be good to go.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...