Jump to content
Corsair Community

CMX512-3200c2pt will not run at 400FSB


donnieb

Recommended Posts

I have the following:

Asus A7N8X-X motherboard

CMX512-3200C2PT memory

AMD Barton 3200+ CPU

 

I cannot run the memory at 400 FSB without the system crashing or stopping programes running, the memory is set to 2.5, 3, 3, 6 with voltage of 2.7.

 

The memory will run ok at 266, can you please help?

Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...