Jump to content
Corsair Community

Computer won't POST M2N


Srose

Recommended Posts

My Setup:

 

AMD Athlon64 3500+

Asus M2N-SLI deluxe

TWIN2X1024A-6400

Geforce 7300GT

 

Now the problem the computer won't even POST it turns off after 4 seconds or so. One time I was able to enter BIOS and cheked the CPU temperature, 40-43 degrees,no problem.. But since that i haven't been able to enter BIOS so i can't change anything.. So i think that something is defect or can a compatible problem cause this?

Thanks!!

Link to comment
Share on other sites

  • Corsair Employees
Please get the latest bios and then load setup/optimized defaults and then set memory Frequency to 667 Mhz and set the Dim Voltage to 2.1 volts (+.2 Volts W/Giga-Byte) and leave the timings set to "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...