Jump to content
Corsair Community

TwinX 2048-3200PT and A8N32-SLI


Recommended Posts

Ok, i bought the TwinX 2048-3200PT in May, it worked on my A8N-SLI, then when i got my A8N32-SLI they didnt work, i updated BIOS, checked the timings and voltage, and even read some forums, so i put in my old kingston memory for now, and RMA'd the Ram. Well today i recieved it back, i put it in, it booted, then went into windows and bluescreened, said it was sysaudio.sys, so i pulled my X-Fi and rebooted, it didnt bluescreen, but the comp ran really laggy, and wouldnt load firefox or a game, so i ut the X-Fi back in, along with the kingston ram, and it runs good now.... please help me :(:
Link to comment
Share on other sites

  • Corsair Employees

Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with http://www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure. In addition, with this MB you have to disable legacy USB in the bios when running any memory test.

.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...