Jump to content
Corsair Community

MSI 865PE NEO2-V showing wrong timings


Mazon

Recommended Posts

Hi

 

I have a MSI 865PE NEO2-V motherboard with Corsair TWINX2048-3200C2 DDR-DIMM 2048MB Kit w/two matched CMX1024-3200C2 DIMMs now and try to put the timings of the RAM to 2-3-3-6 in the bios.

 

According to http://www.corsairmemory.com/corsair/configurator_search_results.html it should work ok...but its not.

 

When i check the timings with CPU-Z it shows 3-4-4-8 instead.

 

The SPD is 3-3-3-8.

 

I have checked so they are in Dual channel and i have put the RAM voltage to 2.75V after i tried with the default voltage, but to no avail.

 

To be extra certain i ran Everest Ultimate and it showed the exact timings.

 

The RAM run fine with StressPrime and Prime95 but i get bad results in SiSoft Sandras RAM benchmarks.

 

What is going on????

Link to comment
Share on other sites

  • Corsair Employees

If you have a XMS module that ends with a "C2" designation the SPD will be set to JEDEC defined values for the IC used to make that specific part and the tested settings would need to be manually set!

 

And if you are looking under the SPD tab that will not change and it would be correct to show at Cas 3-3-3-8 the tested settings would need to be manually set and then under the Memory Tab you should see what’s actually be set!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...