problem

[IonNuke]

Ram Guy,

 

I'm having the same problems as posted here and I also have the same CPU Athlon64 3000+ (socket 754) and Chaintech VNF3-250 motherboard.

 

I wrote down all the settings that you suggested but I still can't get past post to the prompt to boot into memtest86.

 

Do you think the memory modules are defective???

I doubt they are but you never know because my system was working fine for a couple years until the other day I had a harddrive crash and now everything starts to fall apart.

 

(but i'm using the CMX512-3200C2 (two modules))

[RAM GUY]

Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.