Laric Posted May 4, 2006 Share Posted May 4, 2006 I have just gotten TWINX2048-3500LLPRO for my Abit AN8 Fatality mb. The problem I have is incredible instability. Since it is your recommended memory for that motherboard according to your configurator I am assuming that some setting must be changed? Should I leave everything in the memory setup as Auto or should I use By SPD or what should I do. And should I go into my uGuru settings and change power for ddr modules or? I kinda need help as my system was much more stable with my old worse memory than it is now with the new supposedly much faster memory. Michael Link to comment Share on other sites More sharing options...
CandyKid Posted May 4, 2006 Share Posted May 4, 2006 Welcome to the forums, Laric! XMS Qualification & Testing Please MANUALLY set these: Testing parameters for TWINX3500LLPro: TWINX2048-3500LLPro Data Sheet Motherboard make and model: Asus A8N-SLI Premium Each pair is tested and packaged together using the following settings: CPU External Frequency: Manually set to 217MHz DRAM Clock: Manually set to 1:1 or 400MHz This setting is to make sure you're running your memory and CPU's FSB in sync, then you overclock your CPU to a 217MHz FSB using the previous 'External Frequency' setting. SDRAM CAS Latency: 2.0T SDRAM RAS to CAS Delay (tRCD): 3T SDRAM Row Precharge (tRP): 2T SDRAM Active to Precharge Delay (tRAS): 6T SDRAM Bank Interleave: 4 Bank SDRAM VDIMM: 2.75 Command Rate 1T All other settings are motherboard defaults. Maximum recommended VDIMM: 2.9 PLUR CK Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.