Federov Posted May 1, 2006 Share Posted May 1, 2006 I just recently upgraded my CPU And Mobo to a AMD64 4400 X2 and need a kit or something so I can use my Hydrocool on it. I looked everywhere for HC200-1040 and it's been discontinued for sometime now, no one carriest this item. =/ Is there a alternative to this? Any help would be appreciated! :) Thanks! Link to comment Share on other sites More sharing options...
Federov Posted May 1, 2006 Author Share Posted May 1, 2006 Anyone know if this would work with it? Not even sure if this is the same tubing =/ http://www.crazypc.com/items/9308.html Link to comment Share on other sites More sharing options...
KaptCrunch Posted May 1, 2006 Share Posted May 1, 2006 not unless you get 3/8" ID tubing (Note: to use from WB to HCX with 3/8 just cut the HCX tubing, 5/16" from the Quick connect hose barb end | <<<[ ] and a pot of hot water dip an push over 3/8 tubing on HCX 1/4 then use gear clamp to hold it.) for best results use 3/8 to 3/8 connector quick connect (so to open the flow rate an remove ELBOWS) also get the bulkhead type to mount in HCX case Link to comment Share on other sites More sharing options...
Federov Posted May 1, 2006 Author Share Posted May 1, 2006 Thanks for the info! :) Is it smart to change to a aftermarket core? Will I run in to problems? Is there a better core to use that others use? Any help is much appreciated, I don't want to waste money or break anything. Link to comment Share on other sites More sharing options...
KaptCrunch Posted May 2, 2006 Share Posted May 2, 2006 If you want just add in the loop, CPU>RADadd-on>GPU an leave orginale in place. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.