Jump to content
Corsair Community

Bad mem. twinx1024-3200XLPRO


OmesStar

Recommended Posts

After two years memory was working fine, then one day my computer would no longer run through its startup. Finnaly I found out that it was one of the two sticks of ram I have, because once I took it out it worked perfectly. I tried putting them together in serveral variations and by itself, with no success. I would assume this would qualify under the warrenty, but just checking :).
Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.8 volts (+.2 Volts W/Giga-Byte) and then set the timings manually to "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...