Jump to content
Corsair Community

Bad module


seafrench

Recommended Posts

I was having alot of corrupt file errors and random crashes so I decided to use a memtest86 boot disk. One of the modules came up with a flurry of errors when running Test 7 (Random number sequence). I then pulled that module and have had no problems since. Should I send that module in?

 

I purchased the module from zipzoomfly.com about 2-3 years ago.

Link to comment
Share on other sites

  • Corsair Employees
Please load setup/optimized defaults and then set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...