Jump to content
Corsair Community

Consistent System Failures now


Recommended Posts

I've a pair of 1 GB cards





I purchased at Frys in mid Dec, then submitted rebate form.


They worked fine until yesterday. Now my system keeps rebooting itself.

Have done the following:

Reset BIOS values to default

Replaced system drive

Replaced operating system [W2K]

Removed all other drives


Cannot run memory or any other diags, because the system won't stay up long enough.


Pulled the two Corsair cards, leaving in a pair of 512K cards, and the system is rock solid again. Sounds like a memory problem to me.


Sounds like a memory issue to me.


pls advise.

Link to comment
Share on other sites

  • Corsair Employees
Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...