Twin2x1024-5400c4pro Please Help

[occtec]

Hi im trying to configure my latency timings can anybody tell me what i should set the last one to pls, not even sure what it does i was just told to set my latency to 4-4-4-12?

 

CONFIGURE DRAM TIMING BY SPD (DISABLED)

DRAM CAS# LATENCY 4 CLOCKS

DRAM RAS# PRECHARGE 4 CLOCKS

DRAM RAS# TO CAS# DELAY 4 CLOCKS

DRAM RAS# ACTIVATE TO PRECHARGE 12 CLOCKS

DRAM WRITING RECOVERY TIME 4 CLOCKS (NOT SURE IF THIS IS SET RIGHT & WHAT IT DOES)

[RAM GUY]

You can follow the link in my signature for the tested settings and I would set the memory voltage to 2.0 Volts as well.

[occtec]

Ok ive tried that but for some unknown reason when i set my RAM to 533Mhz and then overclock my CPU to 250Mhz my PC on reboot runs at 4.0Ghz? :(:

 

ok, so what ive done with my Asus P5LD2 Deluxe mobo is manually overclocked the ram to run at 667Mhz and then went into the latency settings and changed them to,

 

CONFIGURE DRAM TIMING BY SPD (DISABLED)

DRAM CAS# LATENCY 4 CLOCKS

DRAM RAS# PRECHARGE 4 CLOCKS

DRAM RAS# TO CAS# DELAY 4 CLOCKS

DRAM RAS# ACTIVATE TO PRECHARGE 12 CLOCKS

DRAM WRITING RECOVERY TIME 4 CLOCKS (NOT SURE WHAT TO SET THIS ONE TO)

 

Also what would you recommend me to set the ram voltage to 1.9 or 2.0 volts and should i manually set my voltage on my CPU to 1.4 volts, its a Intel P4 3.2Ghz 640 2Mb Cache with Hyperthreading?:confused:

[RAM GUY]

DRAM WRITING RECOVERY TIME: Auto or 5 CLOCKS

And I would set the memory voltage to 2.1 Volts!