Jump to content
Corsair Community

#TWINX1024-3200XL Issues

Mr Pabl0

Recommended Posts

Hello !


Since I bought my modules Ii was thinking that something was wrong. After lot of cracsh games, I ran MemTest+ 1.65 and after 15 minutes of testing : 578 Errors (if I remember right and the computer turned itself off) :,(



My config :


PC : Shuttle SB75G2

MB : FB75 Bios S01D

PS : 250W

HD : 2 Seagate 160 Go RAID 0


CPU : Intel P4 C 3 GhZ


RAM : Dual Channel Enabled, Frequency DDR-400, Voltage : 2.75V


As you can see, no overlocking.


So, what's next ?


Thank you.

Link to comment
Share on other sites

I believe that 3200XL modules require at least 2.8 v. Try increasing the DRAM voltage to 2.8 and rerun Memtest86. If you still get errors, you can try it at 2.85 and 2.90 volts. Corsair does not warrant it for use at voltages above 2.9, however, so I'd suggest not going higher than that.



Link to comment
Share on other sites

  • Corsair Employee
Please set the Dim Voltage to 2.7X volts and then set the timings manually to the tested settings for the specific module you have, and then test the module/modules one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...