waiownsyou Posted November 3, 2005 Share Posted November 3, 2005 1234567890 Link to comment Share on other sites More sharing options...
RJLeong65 Posted November 3, 2005 Share Posted November 3, 2005 Sounds about right. But with four sticks of CMX512-3200C2 memory in that system, it is better to downclock the memory speed to 166MHz (or DDR333). Even Asus itself says so. Link to comment Share on other sites More sharing options...
waiownsyou Posted November 3, 2005 Author Share Posted November 3, 2005 1234567890 Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted November 3, 2005 Corsair Employees Share Posted November 3, 2005 With four modules I would set the memory voltage to 2.8 Volts and set the timings to Cas 3-3-3-8 at 2T Command rate. Link to comment Share on other sites More sharing options...
waiownsyou Posted November 3, 2005 Author Share Posted November 3, 2005 1234567890 Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted November 3, 2005 Corsair Employees Share Posted November 3, 2005 Just let the system boot to a floppy with the timing set to By SPD and then when you set the memory timings to manual on the next post it will set them properly and just leave them at default. Link to comment Share on other sites More sharing options...
waiownsyou Posted November 3, 2005 Author Share Posted November 3, 2005 1234567890 Link to comment Share on other sites More sharing options...
Corsair Employees RAM GUY Posted November 3, 2005 Corsair Employees Share Posted November 3, 2005 These settings are not specified and the default should work. I have tried this with this MB and this is what I had to do to get it set properly But you can try and set them to 14 and 15 respectively. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.