Jump to content
Corsair Community

Bad VS512MB333


lo_rez

Recommended Posts

Hello,

 

I purchased a pack of two VS512MB333 modules. My PC would not boot or install an OS with both modules installed on the MB. I ran the memtest86+ test on both modules, one of the modules failed consistantly. Do I need to send both module back or just the bad one? Do I need to do anything else to get an RMA#?

 

Thanks!

Link to comment
Share on other sites

  • Corsair Employees
Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...