Jump to content
Corsair Community

One bad module in Twinx C2 1024 pack


kaede93

Recommended Posts

One of the two modules makes my computer reboot.

That's why I tried to check the two modules togheter with memtest86 following the instructions I've seen on the forum, but I meet many errors.

Then I tried to test each module separetly:

- one module works fine during 4 passes without error

- one module makes many and many errors always at the same address

 

As a conclusion, I think this last module is defective.

Link to comment
Share on other sites

  • Corsair Employees
Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to the tested settings for the specific module you have, XMS2700C2 Cass 2-3-3-6 for example or if you have Value Select "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...