Jump to content
Corsair Community

Getting error: Page Fault in Nonpaged Area


Imbornlazy

Recommended Posts

  • Corsair Employees
Please set the Dim Voltage to 2.8 volts (+.3 Volts W/Giga-Byte) and then set the timings to "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

  • 5 months later...
  • Corsair Employees

There is only one thing you have to change after you load setup defaults, and thats is to set the memory Voltage to (+.2 or +.3 Volts W/Giga-Byte)!

Please note you may have to use the CNTRL + F1 key stroke to show hidden bios options!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...