Jump to content
Corsair Community

Memory failing diags Arggh!


Axedup

Recommended Posts

  • Corsair Employees

Errors in test 5, 7, or 8 might suggest some other problem.

Please try these settings:

With the A7N8X-E please set the FSB jumper to pins 2-3 with the modules in slots 2-3 and then reset or clear the bios and load setup defaults and set the Dim Voltage to 2.7 Volts and set the timings manually. Then please test the system with http://www.memtest.org.

CPU Freq: 200 MHz

Memory Frequency: 100%

Dim Voltage to 2.7 Volts

Resulting Frequency: 200 MHz

SDRAM CAS Latency: 2.5T

SDRAM RAS to CAS Delay (tRCD): 3T

SDRAM Row Precharge (tRP): 3T

SDRAM Active to Precharge Delay (tRAS): 6T

 

I have had 4 of these exact MB's and this is what had to be done to solve problems with aggressive memory, no matters who's I tested. In addition, a few other's had some success disabling Spread Spectrum in the bios as well. I would take a look at http://www.asusforums.org as well in the AMD section.

Link to comment
Share on other sites

  • Corsair Employees
All of our XMS modules that end with a C2 designation will have theor SPD set to JEDEC defined values and would need to be manually set. In additionn we have alway suggested setting the memory timings manually for all of our modules.
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...