Jump to content
Corsair Community

Reboots


xuk

Recommended Posts

Hello this is my 1st time here. after installing my new 1gb of twinx1024-3200xlpro my computor reboots about every 20-25 minutes. A bonus stick of 512 was sent to me by corsair and I have alternated both out with the others to the same result. Is there certain parameters that I should adjust my voltage to in my bios or any other settings I should adjust. I will need specifics as I am pretty computor illiterate.

 

I havent run memtest86 yet as i will do that tonight.

 

Thank you

Link to comment
Share on other sites

  • Corsair Employees
Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.
Link to comment
Share on other sites

Please set the Dim Voltage to 2.7X volts (+.2 Volts W/Giga-Byte) and then set the timings manually to "BY SPD" and then test the module/'s one at a time with www.memtest.org! If you still get errors, please follow the link in my signature “I think I have a bad part!” and we will be happy to replace them or it! However, if you get errors with both modules that would suggest some other problem and I would test them in another system or MB to be sure.

 

I have set the voltage to said rate but how do I set the timmings to "BY SPD". I cannot find where to change that.

 

Thank you

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...