Jump to content
Corsair Community

K8N Neo4 Platinum/SLI - Memory Configurator


NETCRAMMER

Recommended Posts

Ok. memory noob here. these were recommended. but which is best for gaming?

And are there others not listed that are better (and compatible of course)?

They only listed 1GB I want 2GB. Cost not an issue so what's best?

 

TIA!

 

Most Popular:

TWINX1024-3200C2 / DDR-400 (XMS-3200C2) / *2-3-3-6 / 2.5-3-3-6

Best Overclocking:

TWINX1024-4400C25 / DDR-550 (XMS-4400C25) / 2.5-4-4-8

Lowest Latency:

TWINX512-3200XL / DDR-400 (XMS-3200XL) / 2-2-2-5

XPERT - Configurable On-Module LED Display:

TWINX1024-3200XLPRO / DDR-400 (XMS-3200XL) / 2-2-2-5

Link to comment
Share on other sites

Welcome to the forums, NETCRAMMER!

 

For 2GB on your setup, the TwinX2048-3200C2 would be the best choice.

 

PLUR

CK

 

p.s. FYI, I believe that the A64 systems do not have a problem running CAS 2 on the 3200C2 modules. Not official, but I don't think you'd have a problem.

Link to comment
Share on other sites

The manufacturer MSI has the following post on their site for this board.

Will I have to change these settings with with the recommended memory?

 

Due to the High Performance Memory design, motherboards or system configurations may or may not operate smoothly at the JEDEC (Joint Electron Device Engineering Council) standard settings (BIOS Default on the motherboard) such as DDR voltage, memory speeds and memory timing. Please confirm and adjust your memory setting in the BIOS accordingly for better system stability.

Link to comment
Share on other sites

It would probably boot just fine, but I'll list the settings regardless, for you to manually set or double-check.

 

3200C2:

 

DRAM Clock: 200 MHz

DRAM Timing (overrides SPD values): Manual

System Performance: Normal

SDRAM Bank cycle time (or tRAS): 6

SDRAM Bank Interleave: 4

SDRAM Row Precharge (tRP): 3

SDRAM RAS-to-CAS Delay (tRCD): 3

SDRAM CAS Latency: 2 (2.5 on AMD platform)

Command Rate: 1T

All other settings are motherboard defaults.

 

Additionally, I'd set the DDR Voltage/VDimm to 2.75 or 2.8 volts.

 

PLUR

CK

 

p.s. That warning basically says this: Don't use extremely cheap modules as they won't keep up with the system.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...